How to Repair Holes in Drywall With Spackle Colorado

Steps

1. Assess the size of the hole. Spackle repairs holes up to the size of a hand or so, but any hole larger than the size of a fist will require the use of a support of some kind, unless they happen to have support behind the wallboard already.
2. Choose the correct spackle. One way to classify spackle is by weight: the smaller the hole, the lighter the spackle you will need.
3. Cut any loose or hanging pieces from the hole with a utility knife, or any sharp knife. Don t make the hole any bigger than you have to, but do make sure to remove any crumbling or unsupported wallboard gypsum.
4. Choose a spackle knife of an appropriate size: slightly larger than the hole. If you are unsure, use a larger one.
5. Stir the spackle, especially if you are using a previously opened spackle tub.
6. Load some spackle onto your spackle knife.
7. Press the loaded side into the wall about a half-inch (20 to 30 mm) above the hole.
8. Press hard, and using a smooth stroke pull the knife down over the hole. Usually, pulling over the hole at a slight angle works best.
9. If the spackle begins to sag leave this coat to dry in the current state and come back later for a second coat. It is better to give a hole several thinner coats than one thick one.
10. If needed, apply a second coat only after the spackle is fully dry.
11. Make the spackle as flush as possible, but remember that spackle shrinks. Do not be afraid to leave a slight mound (perhaps an eighth of a inch) above the hole.
12. Smooth the spackle down with very fine grade sandpaper or use a damp sponge to smooth out the surface until it is flush with the wall.
13. Small holes do not need primer, but larger holes should be primed to seal the spackle and prevent it from absorbing too much of your top coat paint.

Tips

• The trick is to press as hard as you can. Spackle knives are flexible so they can act something like a spring to push the spackle into the hole. Pushing hard helps this to happen.
• Do not use spackle that contains dried lumps as this will lead to more problems.
• If spackle falls to the floor hitting the carpet or furniture the best thing to do (especially when using a lightweight spackle) is to let it lay until dry. Spackle loses moisture quickly. Once dry spackle will just lift up.
• When putting spackle away always close the lid tightly.
• Tightly ball up a plastic sandwich bag and dab at the spackle after applying to simulate wall texture. Lightly sand by hand after to flatten out excessive shadowing.

Warnings

• Some companies sell metal mesh products for larger holes. These can be hard to use, and if used incorrectly quickly introduce more problems than they solve.
• Make sure you use spackle and not similar products like caulk.
• Wash your spackle knife promptly as spackle dries quickly. Never use a dirty spackle knife or one that has been bent or is out of shape.
• Very large holes or missing pieces of wallboard will need to be replaced using new wallboard and mud compound as described in How to Patch a Wall.

Things You'll Need

• Spackle
• Springy spackle knife
• Sand paper or sponge

Article provided by wikiHow, a wiki how-to manual. Please edit this article and find author credits at the original wikiHow article on How to How to Repair Holes in Drywall With Spackle. All content on wikiHow can be shared under a Creative Commons license.