Steps
- Brush the walls and floor of the swimming pool to remove as much of the algae as possible. This will greatly reduce the amount of time it takes to kill and clear the algae bloom.
- Ensure that the pH level is within the range of 7.2 - 7.6. This will ensure that any chlorine added will work more efficiently - high pH levels in particular will impair the efficiency of the chlorine doing its job.With the pool filter system running, add a chlorine based swimming pool shock at the rate of 1 lb. per 7,500 gallons (or follow the pool shock manufacturer s dosage suggestion for killing algae). The pool filter system should continue to run 24 hours a day.
- If the condition of the swimming pool does not significantly improve after 12-24 hours of filtering, add a second dose of chlorine pool shock at the increased rate. Repeat this process until the algae has been eliminated.
- Once the algae is dead it will turn a white or grayish color, and it will be suspended in the pool water or settle to the floor. When there is no longer any sign of the color green in your pool, thoroughly vacuum the swimming pool. It is recommended that you vacuum dead alge to waste and not through filter.
- The pool filter should be backwashed or cleaned to be sure that dead algae is not trapped inside the filter. If the filter is not thoroughly cleaned the algae may quickly return.
- Test and balance all of the pool chemical levels using the following guidelines. Free Chlorine: 1-3 ppm, pH: 7.2 7.6, Alkalinity: 80 120 ppm and Calcium Hardness: 200 350 ppm.
- Begin adding an algaecide pool chemical on a weekly basis to prevent algae from returning.
Tips
- Pay closer attention to the chlorine level of your swimming pool water in the future. Algae and harmful bacteria are almost immediately destroyed by a free chlorine level of 1 ppm or higher. You have experienced an algae problem because you have not properly maintained the chlorine level, and it was allowed to drop below 1 ppm. Test pool water frequently and make any necessary adjustments for a clean, safe and easy to maintain swimming pool.
- Chlorine pool shock needs to be dissolved in a large bucket of water before it is added to the swimming pool. Always add chemicals to water when dissolving. NEVER add water to chemicals.
- Monitor your pool filter system closely during this entire process and thoroughly backwash or clean the filter each time the pressure rises 10 psi. above the normal operating pressure. The dead algae that your pool filter collects may quickly dirty the filter, and need to be cleaned out frequently.
- Phosphate Levels - high levels of phosphates in pool water will result in your pool using much more chlorine than usual. They are also one of the main food sources for algae, therefore it is important to have these levels checked fairly regularly especially if the pool seems to be using more chlorine than usual. I have seen a pool with a particularly bad case use approx. 2.5 times the amount of chlorine that it should have, making it very difficult to maintain.
- In the winter, invest in a mesh pool cover that will prevent debris from entering your pool, yet allow water to pass through, and keep your pool clean.
Warnings
- The swimming pool cannot be used until the algae is dead, and the chlorine level of the pool water has returned to a safe level of 3 ppm or less.
Sources and Citations
- http://www.usapoolpros.com/how-to-clean-a-green-pool
Article provided by wikiHow, a wiki how-to manual. Please edit this article and find author credits at the original wikiHow article on How to How to Eliminate and Prevent Green Algae in a Swimming Pool. All content on wikiHow can be shared under a Creative Commons license.